Tag Archives: Power Transformer

The quality of corrugated board production line at the temperature and velocity are closely related. Some high-speed Facer, even in low temperatures can be maintained more quickly, the key is fitted with a temperature regulator. Over the years has proved that these are equipped with low-temperature regulator Facer for high-speed production of superior quality corrugated board manufacturing. A fast speed, the temperature must be controlled starch adhesive. The equipment allows the machine in the twenty-four hours of continuous production of 23 varieties of the average hourly change in the case of bonding adhesive to ensure the quality of cardboard.

The machine speeds up to 300 meters per minute. If the transformation varieties equipped with computer control system, can immediately change specifications, but also very close to the average production rate of maximum speed.

Temperature regulators can be assembled in various parts of the Facer, its main features are as follows:

1. Low-temperature adhesive process can be carried out, thus eliminating the phenomenon of warping and cracking, to improve the quality of cardboard;400HZ Transformer

2. Applicable to low water content of the semi-gel adhesive, the required vapor pressure lower than 40% of conventional equipment, saving energy;

3. Since the standard starch through special processing, adhesives can all gel, so even though the amount of reduction, but it can ensure there is enough top corrugated adhesion strength;

4. Adhesive gel fast, single-and double corrugated cardboard to keep the same speed, so that further accelerate the production rate, improve production efficiency;

5. Single machine in the amount of adhesive used on the machine and double the amount used on nearly the same, so the production of cardboard remain flat;

6. Noise kept to a minimum. Single machine and double-sided machines are sealed in a small room to block preheater heat and reduce noise;AC Power Conditioner

7 day, two shifts, changing 400 kinds of specifications, the production line moving speed is almost unabated. Facer average speed just below the design speed of 5%. Access is not required to reduce paper machine speed, floating adjustable rollers ensure perfect high-speed access paper;

8. Adhesive is located in the single-sided machine, paste machine and double-sided adhesive between the heating plate transport. This device is to reduce the water content of low viscosity and high viscosity of the adhesive plate to ensure that temperatures in the low-heat gel designed.

Market demand for the corrugated industry continue to change the status quo, the rapid development. West Germany, a company has on all new machines have adopted the principles of design type. This design features are: make single and double Facer Facer free crack in a rack mounted, corrugated specifications change very quickly. Two kinds of corrugated transformation process, ready to warm up and turn the roller until the change over. Jane rolls loaded with independent hydraulic system, change is not required to make any adjustments;

Preheater and pre-existing demodulator can be used as usual, if the length of the machine and then get enough speed, the unit can be directly put something complete; pressure roller and the positioning data are Corrugated instructions do not need to install regulator ; hose is not disconnected, valve automation; machine has increased the strength of corrugating medium embedded line equipment. These features enable the operator to high-speed production lines moving in the case of a few minutes transform corrugated specifications.AC Voltage Regulators

In order to match with the single machine, glue machine is specially designed to allow the performance as long as the paper is entirely consistent with single-sided machine. Starch is always in line with the application of machine speed range, across the roll width. This plastic machine roll control on the roll gap adjustment device by a specific adjustment, in order to maintain parallel; single-sided corrugated volumes were effectively controlled, eliminating the beating or side edges curl, to maintain contact between the roller on the angle does not change; starch films in the primaries of the machine can automatically adjust the speed range can be low for some paper in case of machine speed to compensate for the high absorption rate.

All basic features of the machine is the machine has automatic diagnosis system, the use of color signals that the machine position and breakdown, and proposed suggestions and troubleshooting steps. As the continuous development of modern science and technology, corrugated industry maturing.